- Can be used to heat relief powder and shrinkable sheet
- Keeping 3-5cm distance from work and about a 45-degree angle to heat until it is completed.
- After completion, use the heat gun at a high temperature to blow a few minutes,
- it not only can add its hardness but also its brightness
- The temperature can not be adjustable, in theory, it can reach 200 degrees within a few seconds
- Do not work over 10 minutes, blow at a 45-degree angle to avoid heat suck.
- Be careful when using
- Material: Steel Plastic
- Working temp.: 200 °C
- Rated Power: 300W
- Rated voltage: 220V 50-60Hz
- Plug Type: EU Plug
Item specifics
- Brand Name: TONGFENGLH
- Rated Voltage: 220V
- Rated Output Power: 300W
- Usage: Home DIY
- Air Volume: 150-260
- Feature: Other
- is_customized: Yes
- Weight: 220g
- No-Load Speed: 1200rpm
- Model Number: TON220V
Customer Reviews
Works fine, took for a shrink tube. The temperature is sufficient.
There was a small problem, increased noise and vibration when working. It's an unbalanced impeller. Balanced, drilled where it is necessary to recess and the problem passed.
Initially, the shaft hole in the impeller is offset, hence the vibration.
Shop and seller are good. Delivery in time, with tracking. Everything is fine!
Works well. The cord is very short, less than a meter.
Heats quickly, works normally. Thought it would be smaller, and the hair dryer was straight large. But it's our fork. No need for adapters.
Small thermal stripper very handy and heats very quickly. Extra to heat silicone electrical connectors used to connect two electrical wires together.
Great purchase
Everything matches. Only here the delivery for two weeks delayed. And in general-thank you